Most glycol will break down and become acid needing immediate replacement if those temperatures are reached.
Glycol replacement in solar panels.
The other factor specific to solar glycol is is ability to completely vaporize or steam when stagnation temperatures are present.
Antifreeze fluids degrade over time and normally should be changed every 3 5 years.
An antifreeze change may be required for your solar system.
The renewable green alternative to ethylene or propylene glycol has a slower thermal degradation rate than both ethylene glycol and propylene glycol and outperforms propylene glycol s viscosity at lower temperatures.
A solar collector mounted on the roof absorbs energy from the sun and transfers it to a medium usually a water glycol mixture which is then pumped to a coil in a tank where it heats up the water.
It s non toxic biodegradable and relatively stable.
The antifreeze is normally non toxic propylene glycol as opposed to toxic ethylene glycol.
Air in the loop can cause pump.
Food grade propylene glycol the other kind like normal antifreeze is quite toxic if ingested different uses have different formulations get the one for solar panels.
For solar thermal applications mixtures based on propylene glycol or the green glycol are recommended.
Sentinel r100 solar thermal fluid is glycol based and designed for use in solar heating equipment operating up to 200 c.
During static conditions the solar collectors should be completely empty so that the thermal fluid is not exposed to extreme temperatures.
This is not always the case we will test the condition of your system before we do.
However you should always mix as much water as possible with your choice of glycol product as simple water is the ideal solar fluid.
When commissioning a pressurized glycol solar hot water system it is essential that all the air in the solar loop is removed.
Solar water heating systems that use an antifreeze solution propylene glycol or ethylene glycol as a heat transfer fluid have effective freeze protection as long as the proper antifreeze concentration is maintained.
Most solar thermal systems use antifreeze as the liquid to transport heat from the solar panel to the cylinder.
However there are a few drain back systems that only use water.
Solar glycol such as prosoltm l ht is rated to 425 f with short periods of up to 475f.